Add a Milling Table to your drillpress

I like this build but I am a little mixed on doing this.  The quill on a drillpress isn’t exactly built for side to side movement.  More up and down.  So with light materials I guess this would be OK, but I could see problems with heavier materials damaging the drillpress.  Or course looking at the mill table you aren’t going to put heavy stuff on it to begin with…

http://www.instructables.com/id/MK-DIY-Milling-Table-for-Drill-Press/?ALLSTEPS

This entry was posted in Cheap, Tools. Bookmark the permalink.

3 Responses to Add a Milling Table to your drillpress

  1. Wow that was unusual. I just wrote an incredibly
    long comment but after I clicked submit my comment didn’t appear.
    Grrrr… well I’m not writing all that over again. Regardless,
    just wanted to say excellent blog!

  2. Hi there to all, the contents present at this website are really amazing for people experience, well, keep up
    the good work fellows.

  3. Hi there! I know this is somewhat off topic but I was wondering if you knew where I could get a captcha
    plugin for my comment form? I’m using the same blog platform as yours and I’m having problems finding one?
    Thanks a lot!

Comments are closed.